Insert a spool of thread on the spool pin. In some models one should pull up the spool pin.
Holding the thread from the spool with the help of right hand, pass the thread in the grove on the thread guide towards your direction.
Next, pass the thread around the pre-tension disc and pull the thread in completely.
Pass the end of the thread through the hole on the bobbin from the inside of the bobbin.
Insert the bobbin onto bobbin winder shaft and slide the bobbin winder shaft to the right. Turn the bobbin by hand in clockwise direction until the projection slides into bobbin notch. Make sure to keep about 3-4 inches of thread from the hole of the bobbin.
Turn the machine on. While holding the end of the thread, gently press the foot controller to wind the thread around the bobbin a few times.
Stop the machine and trim the excess thread above the bobbin (leave about 1cm of thread from bobbin hole).
Press the foot controller again to start. When the bobbin becomes full it begins to spin slowly.
Take your foot out of foot controller, cut the thread, slide the bobbin winder shaft to the left and remove the bobbin.
No comments:
Post a Comment